SS III Series of DC Pulse Magnetron Sputtering Power Supply

SS III Series of DC Pulse Magnetron Sputtering Power Supply


Technical Specification of DC Pulse Magnetron Sputtering Power Supply, SS III Series

SS III series of magnetron sputtering power supply works in two-stage high frequency conversion mode with unipolar output mode, independent adjustment of the current supplied and the pulse width. When it works in pulse mode, the sputtering target works in high frequency intermittent state, enabling the stored charge on surface of the target to have certain discharging time. This is beneficial to restrain arc discharge and surface poisoning of the target, suitable for reaction sputtering film.

Power Range


Input Power

AC380V±10%, three phase four wire system, 50-60Hz

Output Mode


Pulse Width


Output Voltage

No load 1000V [peak voltage]

Output Features

Constant current / constant power / constant voltage

Arc extinguishing time


Output Stability


Cooling Mode

6-12kW air-cooled; 20-120kW water-cooled

Service Environment

Ambient Temperature 0-40℃
Ambient humidity: Relative humidity ≤85%
Clean air, no dust, no corrosive flammable gas, good ventilation

Cooling Water

Clean without any minerals and other soluble substances
Water Temperature 20-40℃
Pressure 0.15±0.05MPa

Communication Mode


Description: The power supply output properties can be adjusted according to application need

Contact Us

If you have any suggestions, please contact us

Technical Support

Convenient, fast and thoughtful service

Add.: 2000m to the south of Lihe Bridge, Jianshe Road South, Zunhua City, Hebei ProvinceTel.: +86 (0)315-6028868/ 6028898
Fax.: +86 (0)315-6028838  P.C.: 064202  Website: